i half-dropped my car today
#1
Racer
Thread Starter
i half-dropped my car today
my dad helped big time
gonna work on the rear tomorrow - the last pic is the "90-97 ACCORD LOWER CONTROL ARMS" i bought off ebay, and they don't look anything like the beat up shit on my car
gonna work on the rear tomorrow - the last pic is the "90-97 ACCORD LOWER CONTROL ARMS" i bought off ebay, and they don't look anything like the beat up shit on my car
#3
Racer
Thread Starter
neuspeed race, tokico blues, new fron upper arms / front lower ball joints / front tie rod ends / front SPC camber kit went on today ... tomorrow's gonna be rear upper ball joint and washer kit, struts & springs unless i can find some more shit to replace at autozone in the morning. hella squeaks in the back, i was excited about the LCAs...
#4
Senior Moderator
Regional Coordinator
(Mid-Atlantic)
Regional Coordinator
(Mid-Atlantic)
iTrader: (6)
#15
Drifting
I've have the same springs and actually got some tires and alignment today...was not as bad as I thought it would be. my camber varies from -1.0 to -1.6. caster changed 1.5 degrees on both sides. I didn't do the washer trick though.
#16
CL in lawnmower status
looks good, i think you need a side pic to show how dropped your car is, not a front pic again, you already posted two of those, lol
how much is the alignment gonna cost you?
how much is the alignment gonna cost you?
#17
Drifting
I know I'm not the OP but mine was $80 and that seems like the going rate at any shop, just make sure you use a reputable shop. This was my second alignment, besides getting new tires, the first alignment wasn't much of an alignment and they all charge the same for it.
#18
Senior Moderator
Regional Coordinator
(Mid-Atlantic)
Regional Coordinator
(Mid-Atlantic)
iTrader: (6)
#22
Senior Moderator
Regional Coordinator
(Mid-Atlantic)
Regional Coordinator
(Mid-Atlantic)
iTrader: (6)
#23
Racer
Thread Starter
ok
not in the budget at all. Was looking at spacers for the rears especially but not important enough to me.
not in the budget at all. Was looking at spacers for the rears especially but not important enough to me.
#24
Racer
Thread Starter
went by tonight, worst pics I could get
I don't get why the front's mega dumped and the back looks stock...
#25
CL in lawnmower status
yeah the back looks a little high, but i think most ppl's took a little time for the springs to settle and drop a little more, or something like that. (I don't really know from personal experience cuz i still have 4x4 status)
and yes those were almost the worst pics, but the last one gives a somewhat clear indication of the drop
the cl looks good tho, and the svx doesn't look bad either
and yes those were almost the worst pics, but the last one gives a somewhat clear indication of the drop
the cl looks good tho, and the svx doesn't look bad either
#26
Senior Moderator
Regional Coordinator
(Mid-Atlantic)
Regional Coordinator
(Mid-Atlantic)
iTrader: (6)
do you have a 3.0?
#28
Senior Moderator
Regional Coordinator
(Mid-Atlantic)
Regional Coordinator
(Mid-Atlantic)
iTrader: (6)
good call, was posting in a hurry
#29
Drifting
^^^ah, 2.2 I was wondering why so high, since I'm rolling on the same springs, my rear is just tucking into the fender.
#31
#32
Senior Moderator
Regional Coordinator
(Mid-Atlantic)
Regional Coordinator
(Mid-Atlantic)
iTrader: (6)
u get the award for the worst pics
#34
Senior Moderator
Regional Coordinator
(Mid-Atlantic)
Regional Coordinator
(Mid-Atlantic)
iTrader: (6)
did you get the adjustable ball joints?
#35
Racer
Thread Starter
#36
Racer
Thread Starter
on a 1.75" drop how much should I have cut off the stock bumpstops? I'm bottoming out on bumps @ front left, sounds like shit, makes me cringe ... i cut half off all the way around. Measured mine next to a stock today and it's like 1.75" / 2" on my 3.0 races (on my 2.2) ... forgot what a bitch it is driving a dumped car. Oh well.
Thread
Thread Starter
Forum
Replies
Last Post
bearingman07936
5G TLX Audio, Bluetooth, Electronics & Navigation
6
01-07-2016 03:22 PM